Cummins 525 kva Generator Set
Sanchai Diesel Genset SCDG-420 Ø Standard Configuration Engine（Sanchai SCTAA19-G5） Radiator 50°Cmax, fans are driven by belt, with safety guard 24V charge alternator Alternator: single bearing alternator IP23, insulation class H/H Absorber Dry type air filter, fuel filter, oil filter...
The diesel generator set consists of a diesel engine, an AC synchronous generator, a control panel, and a chassis, a coupling, a radiator, a fuel tank, and the like. Some also have a muffler and a cover. Direct connection between the shafts of diesel engines and generators. Usually, a flywheel is also mounted on the main shaft to increase the smoothness of the operation. Diesel generator sets are generally assembled by the manufacturer as a complete set of units; others are based on the electrical load and its characteristics, after determining the capacity and number of generators, and then selecting the diesel engine that drives the generator. The fuel system and the starting air system can be configured individually or in multiple units.
Sanchai Diesel Genset SCDG-420
Radiator 50°Cmax, fans are driven by belt, with safety guard
24V charge alternator
Alternator: single bearing alternator IP23, insulation class H/H
Dry type air filter, fuel filter, oil filter
Main line circuit breaker
Standard control panel
Two12V batteries, rack and cable
Ripple flex exhaust pipe, exhaust siphon, flange, muffler
1. Basic parameter
In-line, 6 Cylinders, Four-stroke
Mode of Speed Regulation
2. Exhaust Air System
Exhaust air capacity
Exhaust air temperature
Max. exhaust back pressure
3. Air Intake System
Air Intake Type
Turbocharged, Water-Air cooling
Max. Air Intake Pressure
Air Combustion Capacity
4. Fuel System
206g/KW.h，100.6L/h (100% loading)
5. Lubrication System
Oil Pan Capacity
Rated Speed Oil Pressure
6. Cooling System
Total Cooling Liquid Capacity
Thermostat Working Temperature
Max. Water Temperature
Model and number
Stamford HCI 544D
Number of Phase
3 Phase and 4 Wires, “Y” type connecting
Number of Bearing
Telephone Influence Factor (TIF)
How to properly replace the diesel generator oil?
1. Place the generator set in a plane and start the engine for a few minutes to increase the temperature of the oil and then stop the engine.
2. Remove the oil-filled bolt (ie the oil gauge).
3. Place an oil basin under the engine and remove the oil drain screw. The oil can be drained from the crankcase.
4. Check the oil drain screw, seal ring and rubber band. If it is damaged, please replace it immediately.
5. Reinstall the oil screws and tighten them.
6. Lower the oil to the upper position of the grid of the oil gauge.